Monark LT2 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 20)

Freewheel sprocket

When replacing the freewheel sprocket remove frame

covers if necessary. Remove the chain according to

section ‘Chain 1/2” x 1/8”’.

Loosen the axle nuts and lift off the ﬂywheel. Remove

the axle nut, washer, chain adjuster and spacer on

the freewheel side. Replace sprocket-adaptor and

assemble the new parts in reverse order according to

the above.

NOTE! Do not tighten the axle nut completely. It

must be possible to loosen the sprocket-adaptor half

a turn.

The sprocket should be lubricated with a few drops of

oil once a year. Tilt the cycle to make it easier for the

oil to reach the bearing. See Fig: Lubrication.

LT2

Fig: Lubrication

Fig: Hub assembly

1 2 ... 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Monark LT2 Anleitung zur Fehlerbehebung Seite 20